Tips and exhortation on Sanding and Sealing parquet floors
This is a manual for follow kindly take more time to peruse and comprehend and ideally look for more guidance if necessary.
Whenever you have wrapped up laying your parquet floor squares or hardwood floor start by utilizing a 50 coarseness sand paper and work askew Parkettboden kaufen across the floor generally with the grain of the floor. In the event that you are sanding an old floor, utilize a lower coarseness of 36 to remove the old veneer you can go all ways over the floor while taking off old polish yet consistently wrap up by going with the grain askew across the floor. Whenever you have completed the process of going over the floor once with a 50 coarseness sanding belt go round the edges with the edger in 50 coarseness sanding circle. Then recurrent go round the edges stirring up the corn meal 50 coarseness then 80 coarseness then, at that point, finally 100.
Go all around the floor with a 80 coarseness on the large belt sander then, at that point, rehash once done with a 100 coarseness in every case askew across the floor changing witch corner to corner to take each time.so once one way then up a coarseness and go slantingly the other. When you have the entire floor up to 100 coarseness then fill. Stir up pitch filler with the sanding dust out of the edger it is a better residue. Then with a filling blade fill the entire floor ensuring you push the filler down the breaks “more is always better”. Best pass on to dry over night or three to four hours. Finish the floor with a last sand of 120 coarseness ensuring all filler is eliminated and sanding with the grain slantingly. Clean the floor when gotten done with a float, clean all skirtings and window sills ensuring all residue is up leave about 30 minutes for residue to settle then tack the entire floor with tack material or wet fabric.
Presently prepared for getting done, I suggest a water base polish like bona mega or comparable or for high traffic regions bona traffic or comparative. Begin by applying veneer to the edges with a brush then on to carrying out the finish with a roller on a post, utilize a short mole haired roller and spread the laquer reliably. Leave no huge puddles of enamel as this will show and take more time to dry. Cover the entire floor and pass on to dry for around two hours then rehash and cover floor utilizing same interaction and leave over night. Toward the beginning of the day the laquer ought to be dry and prepared for a light sand ideally with a screen machine or a fine sand by hand 150 coarseness or higher. Float clean and wipe with tack material or wet fabric.